Half Check Collars (martingale collars) are made for the Leather Section plus rings to pull closed to the measurement that is entered when the order is placed. The Collar will encircle the neck firmly in the tightened state when pulling against a lead (see picture on left) however the Collar will hang loose around the neck when the chain section is allowed to open up if not attached to a lead or the pressure on the lead is slackened (see picture on right).
To measure for a Half Check Collar please measure the Smallest Part of the neck (up behind the ears) with a soft tape measure pulled reasonably tight (so it does not strangle your dog but is not too loose) then enter that measurement when ordering, the Collar Leather Section and rings will be made to pull closed in the tightened state to that measurement for you. The chain section of the collar when allowed to slacken will open the Collar up by a further 10.2cm (4") allowing the collar to go over the head and to drop to the base of the neck and hang loose around the neck when in the relaxed state and is made of 2.5mm chain link.
PLEASE NOTE, if you decide that you would prefer the loose state to be tighter you can deduct a little from the measurement taken for the leather section to pull closed to as once made the size cannot be altered.
The Coloured Crystal Studs I use are set in an Outer Rim to secure them to the leather and come in the following colour choices
Light Siam, Clear, Sun, Olivine , Capri Blue, Deep Tanzanite, Rose Pink, Blue Zircon and Light Topaz.
Crystals add Sparkle and a touch of Bling for that special look
The Stud Choices are Knots, Staff Heads or Roses
I use Top Quality English Bridle Leather for my Products in either
Black, Australian Nut (Brown) and Mid-Tan
Please note - leather is a natural product and skin colours may vary slightly from skin to skin
Studs, Fixtures and Fittings - Brass ( is a gold colour) or Chrome finish ( is a silver colour )